Malaga 3 water heaterThis neat little unit represents a very cost efficient and flexible way of supplying your boat, caravan or RV with hot water. Basically it is a storage water heater (many in the marine world would know this as a calorifier) that has an integrated gas burner and the option to have an integrated 240v immersion heater (750w) aswell. Therefore there are two versions of the heater, Malaga (gas only) and Malage E (gas and 240v). Both of the options are a great way to provide hot water for washing, showering and general use quickly!. If you would like to receive an electronic version of the brochure or installation instructions then please email us and we would be very happy to send you one (or both).
Micro-processor Controller Electronics .
The Propex Malaga 3 water heater is equipped with the latest Propex electronics for accurate digital control of the heater operation and safety functions. The Malage 3 E model switch panel features a 3 position switch for selecting either “gas only” or “gas and 230v”. If you want to use the heater on 230v only, you simply switch off the gas tap that supplies the heater whilst leaving the switch in the “gas and 230v” position. The red L.E.D. on the switch panel lets you know when the gas burner is operating and also, by flashing a certain amount of times, indicates various fault conditions.
These units have some basic, but specific mounting requirements. They are room sealed, hence the combustion air is drawn from outside, and the exhaust is sent back outside, therefore if installed correctly it will comply to BSS regulations. The flue arrangement is basic, the heater is on one side of a vertical wall, the exhaust goes straight through and is capped off on the outside of the wall. This is easy for Caravans and RV's, but can present us boaters with some challenges, therefore if in doubt please ask, thats what we're here for. - The heater should be floor mounted or suitably supported, normally in the bed box.
- The flue is designed to pass through a vertical section of the caravan or boat wall, structural sections of which should not be damaged.
- The flue terminal position should not be closer than 300mm below an opening window or 600mm from a vertical corner.
- Clearences required for installation and servicing: as seen from inside the caravan or boat
LHS 240mm RHS 005mm Rear 100mm Top 005mm 
1 = The external flue cover 2 = Optional cover plate used when replacing a Carver Cascade heater with a Malaga3
.- Large 13 litre capacity - for longer washing and showering facilities
- Efficient gas burner - for faster warm up
- 750W element on Malaga E - use on its own or with the gas burner for even faster hot water
- Small flue terminal - neat appearance outside the caravan
- Safe - combustion products are completely sealed from the caravan or boat interior
- Easy to fit and service - all controls accessible at the rear of the unit
- Electronic control - turns on the heater at the flick of a switch and supervises burner operation
- Automatic resettable overheat cut out
- Compact dimension - more room to route pipework and ducting where necessary
|
LPG Water Heaters 
01353 663 095 
01353 664 514 Co. Reg.2598058